Original data · Lab test
Homemade tincture potency is usually a guess, so we sent four of our homemade tinctures and seven flower samples to an independent laboratory in Ljubljana, Slovenia, to have the cannabinoids measured. The tinctures held 27 to 35 mg of THC and 21 to 26 mg of CBD per gram [1]. All four were fully decarboxylated: less than 1% of their main cannabinoids were still acids, against 88 to 89% in the three raw flowers [1]. Below: the numbers, how to read any lab report, and a total we had to redo.
What we sent and how it was tested
We submitted 11 samples in 2023: four tinctures, coded X1 to X4, and seven flowers identified by batch code. The laboratory, Research Nature in Ljubljana, measured 13 cannabinoids by HPLC-DAD (liquid chromatography with a diode array detector); its report is dated 27 October 2023 [1].
The tinctures were made in a simple beaker, each with a different infusion time and temperature. We cannot state the solvent, the exact times and temperatures, or which flower went into which tincture, so nothing below depends on them.
The results: four homemade tinctures
| Sample | THC | THCA | CBD | CBDA | Total THC | Total CBD* | Acid share |
|---|---|---|---|---|---|---|---|
| X1 | 2.92 | nd | 2.09 | 0.04 | 2.92 | 2.13 | 0.8% |
| X2 | 2.84 | nd | 2.42 | 0.03 | 2.84 | 2.45 | 0.5% |
| X3 | 2.71 | nd | 2.42 | 0.04 | 2.71 | 2.46 | 0.7% |
| X4 | 3.49 | nd | 2.51 | 0.05 | 3.49 | 2.55 | 0.8% |
Values in % by weight [1]; 1% is 10 mg per gram. "nd" means not detected. *Recomputed by us with the report's own formula. Acid share: THCA, CBDA and CBGA as a share of all six main forms.
The results: seven flower samples
| Sample | THC | THCA | CBD | CBDA | Total THC | Total CBD* | Acid share |
|---|---|---|---|---|---|---|---|
| 5P20 | 4.68 | 2.63 | 2.14 | 4.03 | 6.99 | 5.67 | 49.4% |
| 4P5 | 6.90 | nd | 5.83 | 0.50 | 6.90 | 6.27 | 4.1% |
| 7081 | 0.78 | 7.57 | 0.76 | 3.57 | 7.42 | 3.89 | 87.6% |
| 3H51 | 2.00 | 13.92 | 0.39 | 3.30 | 14.21 | 3.28 | 87.7% |
| 6552 | 0.12 | 0.39 | 1.14 | 12.40 | 0.46 | 12.01 | 89.2% |
| IL05 | 5.89 | nd | 5.35 | 0.07 | 5.89 | 5.41 | 1.5% |
| 2N30 | 7.71 | nd | 2.45 | nd | 7.71 | 2.45 | 0.0% |
Flowers 7081, 3H51 and 6552 look like raw cannabis, mostly acids, as the plant makes them [2]. 4P5, IL05 and 2N30 carry almost no acids, and 5P20 about half. That is unusual for raw flower and usually means the material was heated or had aged, since THCA turns into THC in storage, faster when warm [3]. We cannot say which applies here.
How to read a cannabis COA: acid and neutral forms
A certificate of analysis (COA) lists most cannabinoids twice. The acids, THCA, CBDA and CBGA, are what the living plant makes; the neutral forms, THC, CBD and CBG, appear when heat removes a carboxyl group as carbon dioxide [2].
The method decides whether you can see that split. Liquid chromatography (HPLC) quantifies the acids and neutral forms separately [4] [3]. In gas chromatography the hot injector can convert THCA partly or completely, blurring the two [5]. Our report used HPLC-DAD, so every acid has its own line [1]. On any COA, check:
- Unit: % by weight or mg per gram. A dropper measures volume, so mg per ml also needs the liquid's density.
- Detection limit: "nd" means below the limit, not zero.
- Acid and neutral lines: THCA against THC, CBDA against CBD.
- Total formula: printed, so you can redo it.
The 0.877 factor behind Total THC
THCA weighs 358.5 g/mol and THC 314.5 g/mol; CBDA and CBD have the same masses [6]. Losing the carboxyl group leaves at most 0.877 g of neutral cannabinoid per gram of acid; for CBGA to CBG the ratio is 0.878 [6]. Labs report Total THC = THC + 0.877 × THCA, the formula in US hemp testing rules [7] and on our report [1].
Flower 3H51 shows it: 2.00% THC plus 0.877 × 13.92% THCA gives 14.21% Total THC, exactly the lab's figure [1].
How do I know my decarb worked? Look at the acid share
Check the share of cannabinoids still in acid form. In our three raw flowers it was 87.6 to 89.2%; in the four tinctures, 0.5 to 0.8% [1]. Despite different infusion times and temperatures, all four tinctures came out fully decarboxylated and landed in a tight band: 2.71 to 3.49% THC and 2.13 to 2.55% CBD.
No THCA was detected in any tincture, while traces of CBDA, 0.03 to 0.05%, remained [1]. That fits a laboratory heating study in which THCA decarboxylated about twice as fast as CBDA and CBGA [2]. If a report on your tincture shows THCA well above THC, the decarb did not finish; if the acids sit near the detection limit, it did.
Why we recomputed Total CBD and Total CBG
The report's own totals for CBD and CBG did not match its own formula on several samples, so we recomputed them; Total THC matched on all 11. Total CBD differed on 9 of 11 samples and Total CBG on 8, some slightly, some tenfold or more [1]:
| Sample | Total CBD reported | recomputed | Total CBG reported | recomputed |
|---|---|---|---|---|
| X2 | 3.24 | 2.45 | 0.35 | 0.21 |
| X3 | 2.42 | 2.46 | 11.04 | 0.17 |
| 3H51 | 0.39 | 3.28 | 0.16 | 0.98 |
| 6552 | 1.14 | 12.01 | 0.34 | 0.69 |
The largest gaps come from leaving the acid out: flower 6552 reports its CBD alone, 1.14%, while its own 12.40% CBDA brings the total to 12.01%. On any COA, redo the arithmetic. Labs also differ: in Washington State, reported cannabinoid content varied systematically by lab [8].
What it means for estimating homemade tincture potency
Home estimates rest on uncertain inputs, and even commercial labels miss: of 75 edible medical cannabis products, 17% were within 10% of the labelled THC, 23% contained more and 60% less [9]. Our tinctures are one measured reference point, not a rule for yours.
To estimate your own batch, use the potency calculator, the decarb time and temperature chart and the decarboxylation guide, and see how to make cannabis tincture. A COA reports by weight; without the solvent's density, which we cannot state for our samples, mg per gram does not convert to mg per ml.
Limits of this test
- Small sample: four tinctures and seven flowers, one measurement each.
- One laboratory: another lab could report somewhat different values [8].
- Unknown inputs: solvent, exact times and temperatures, and the flower behind each tincture.
- Age: tested in 2023.
- Our recomputation: the corrected CBD and CBG totals are our arithmetic on the lab's values, not a reissued report.
Frequently asked questions
What does Total THC mean on a lab report?
The most THC the sample could hold after full decarboxylation: THC plus 0.877 times THCA [7], a factor that comes from the molecular masses [6].
What does ND mean on a COA?
Not detected: below the lab's detection limit. On our report that limit was 0.01% by weight, or 0.1 mg per gram [1].
How can a lab test tell if cannabis was decarboxylated?
Compare the acid lines with the neutral lines. Our raw flowers were 87.6 to 89.2% acids, our tinctures under 1% [1]. HPLC shows both forms separately [4].
Can you get a homemade tincture lab tested?
Yes, a laboratory that analyses cannabis products can test a tincture like any other sample; ours were measured by HPLC-DAD [1]. Whether a lab accepts private samples depends on the lab and local rules.
Why do lab results differ between labs?
Methods, sample handling and calculations differ, and a study of certified labs found systematic differences between them [8].
Sources
- Research Nature, Institute for Research, Development and Quality Assurance of Natural Remedies, Ljubljana. Certificate of analysis, cannabinoids by HPLC-DAD, 11 samples. 27 October 2023. Not published.
- Wang M, Wang YH, Avula B, et al. Decarboxylation study of acidic cannabinoids: a novel approach using ultra-high-performance supercritical fluid chromatography/photodiode array-mass spectrometry. Cannabis and Cannabinoid Research. 2016;1(1):262-271. doi:10.1089/can.2016.0020
- Taschwer M, Schmid MG. Determination of the relative percentage distribution of THCA and delta-9-THC in herbal cannabis seized in Austria: impact of different storage temperatures on stability. Forensic Science International. 2015;254:167-171. doi:10.1016/j.forsciint.2015.07.019
- Citti C, Pacchetti B, Vandelli MA, et al. Analysis of cannabinoids in commercial hemp seed oil and decarboxylation kinetics studies of cannabidiolic acid (CBDA). Journal of Pharmaceutical and Biomedical Analysis. 2018;149:532-540. doi:10.1016/j.jpba.2017.11.044
- United Nations Office on Drugs and Crime. Recommended methods for the identification and analysis of cannabis and cannabis products. 2009, pp. 32-33. unodc.org
- PubChem compound records, US National Library of Medicine: THC, CID 16078, 314.5 g/mol; THCA, CID 98523, 358.5 g/mol; CBD, CID 644019, 314.5 g/mol; CBDA, CID 160570, 358.5 g/mol; CBG, CID 5315659, 316.5 g/mol; CBGA, CID 6449999, 360.5 g/mol.
- US Code of Federal Regulations, Title 7, section 990.1, Definitions: "Decarboxylated" ((delta-9 THC) + (0.877 x THCA)). ecfr.gov
- Jikomes N, Zoorob M. The cannabinoid content of legal cannabis in Washington State varies systematically across testing facilities and popular consumer products. Scientific Reports. 2018;8(1):4519. doi:10.1038/s41598-018-22755-2
- Vandrey R, Raber JC, Raber ME, et al. Cannabinoid dose and label accuracy in edible medical cannabis products. JAMA. 2015;313(24):2491-2493. doi:10.1001/jama.2015.6613
Related: how to make cannabis tincture, THCA and the potency calculator.
Educational information about cannabis chemistry and lab reports. Not medical advice, not a dosing guide and not a statement about the legal status of any product.